Thursday, February 28, 2013

Origami arrow magnets and tacks

How to make origami arrow magnets
It only takes a minute to make simple origami arrows. They can be used as magnets to hold up your stuff.

How to make origami arrow magnets
I added self-adhesive magnet tape to these, available from craft stores. You could also chop up some of those free magnets that come in the mail with advertisements on them and glue those on.

How to make origami arrow pins
The arrows can also be turned into thumbtacks for your pin board.

DIY origami arrow pins
Lift up the arrow head flap, poke a tack through the paper, and stick the head back down on top of the tack using glue or double stick tape.

I learned how to make the arrows from Joost Langeveld's site. Refer to the instructions there, or read on to see my steps.

How to fold a paper arrow:
Start with a square piece of paper. Origami paper is easiest to fold because it's thin. If you don't mind a bit of wrestling, you can also use regular printer paper like I did for the red and orange arrows. Those were made from 3" squares. The patterned purple arrows were made from 2.5" squares.

I'll add captions below each photo.


With the pretty side down, fold a square paper in half and open it again. (Or as Maria suggested in the comments, just press a little pinch to mark the center. Then your finished arrow won't have a crease running through the center.)


Fold the top and bottom edges inward to meet the center crease.


Fold the two left corners inward at a 45 degree angle. Edges should align with the center crease.


Fold the pointed end over.


Turn the paper over so the point is hidden, then align it so that the point is positioned like the pink line in the diagram (though the point is on the underside and not visible.) Grab the top edge of the rectangle and fold it down, making a valley fold along the dotted line.


The result should look like this. Half of the pointed triangle is exposed.


Rotate the paper 90 degrees counterclockwise. (Well, you don't have to, but I found it easier and that's what the photos show!) Press down with your fingernail at the point where the top layer of paper meets the triangle. Poke your other finger in between the two layers of the flap to open up a little pocket, at the same time folding the long top edge of the flap down to meet the center crease.


Squash the resulting triangle flat.


It should look like this.


Repeat on the bottom side, folding the bottom edge upward to meet the center crease.

How to make origami arrows
It should look like this.

Origami arrow instructions
Flip the arrow over and you're done.

If the arrow wants to pop apart a bit (especially if you use thicker paper), add some glue or double stick tape under any flaps to hold them down.

No comments:

Post a Comment

Get Discount Here